Installation Points of Vertical Slurry Pump

Vertical slurry pump is a device for conveying industrial liquid. The product has good adaptability, can transport corrosive medium, is wear-resistant, and can adapt to different environments when in use. However, installation is very important in use, so what are the key points to be mastered during installation? Let's take a look. 1. The bearing needs to be installed on the bearing box and bearing seat during installation. 2. Then install the prepared felt ring on the bearing box of CNOOC bearing end cover. 3. Then install the B and C parts of the bearing end on the bearing seat and fix them with bolts. 4. Then transfer the installed bearing housing to the shaft and tighten the round nut. At the same time, the bearing end cover needs to be fixed on the bearing box of the vertical slurry pump. 5. Then install the shaft into the bearing seat and fix it with bolts, then screw on the adjusting screw, then fix the bearing on the support seat and install the water retaining ring in a more suitable position. Bearings. 6. After that, it is necessary to fix the connecting pipe to the bearing position slowly, then add the pump cover to the lower part of the connecting pipe, and fix it with bolts after installing the impeller and pump cover. Attention should be paid to the installation of some small parts during installation, and adjustment should be made according to the surrounding environment during installation. Hebei Yingdike Pump Industry Group Co., Ltd. is a professional manufacturer of slurry pumps, submersible slurry pumps and sand suction pumps. It is an enterprise integrating research, development and production in Hebei Province.